Belkin F1DA104Q - OmniView PRO3 PS/2 KVM Switch Manuale Utente Scaricare il pdf (Pagina 35)

3332

section

3332

Using your PRO3 KVM Switch

4. Run “BELKIN Firmware Upgrade Utility.exe”. Click “Browse” to select the FW

upgrade file. Make sure the Comm-port setting matches the port where the

Serial Flash Cable is connected.

5. Apply power to the PRO3 KVM Switch. The KVM Switch will enter into

flash-upgrade mode and wait for the data to upgrade.

6. Click “Write Flash” to start the upgrade. The upgrade process takes about

six seconds. You should see “WRITE OK” display when the upgrade

completes successfully.

7. Disconnect the Serial Flash Cable, POWER OFF the KVM Switch, set the DIP

switch back to the Normal Run Operation position “ON, ON”, and then power

on the KVM Switch. The KVM Switch should be running on the new firmware.

The OSD will display the FW version in the bottom-right corner of the “Main

Menu” page.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Nessun commento

Belkin F1DA104Q - OmniView PRO3 PS/2 KVM Switch Manuale Utente Pagina 35